Forgotten Password And Reset To Factory Defaults; Wireless Networking - 3Com 3CRWE554G72T - OfficeConnect Wireless 11g Cable/DSL Router User Manual

Forgotten Password
and Reset to
Factory Defaults
Wireless
Networking
If you can browse to the Router configuration screen but cannot log on
because you do not know or have forgotten the password, follow the
steps below to reset the Router to it's factory default configuration.
CAUTION: All your configuration changes will be lost, and you will need
to run the configuration wizard again before you can re-establish your
Router connection to the Internet. Also, other computer users will lose
their network connections whilst this process is taking place, so choose a
time when this would be convenient.
1 Remove power from the Router.
2 Disconnect all your computers and the cable/DSL modem from the
Router.
3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL
port on the rear of the Router to any one of the LAN ports.
4 Re-apply power to the Router. The Alert LED will flash as the Router starts
up, and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to
flash slowly, remove power from the Router.
5 Remove the cable connecting the Cable/DSL port to the LAN port, and
reconnect one of your computers to one of the Router LAN ports.
6 Re-apply power to the Router, and when the start-up sequence has
completed, browse to:
http://192.168.1.1
and run the configuration wizard. You may need to restart your computer
before you attempt this.
7 When the configuration wizard has completed, you may reconnect your
network as it was before.
Ensure that you have an 802.11b or 802.11g wireless adapter for
■
each wireless computer, and that it is correctly installed and
configured. Verify that each Wireless computer has either Windows
95 or higher or MAC OS 8.5 or higher.
Verify that your wireless computers are configured to work in
■
Infrastructure mode and not Ad Hoc mode. The Router contains an
Access Point that is designed to operate in Infrastructure mode. Ad
Hoc mode is not supported by the Router.

Forgotten Password and Reset to Factory Defaults

105