Panasonic Lumix DMC-GH2H Operating Instructions Manual page 132

Recording
[PREVIEW HOLD]
[CONSTANT PREVIEW]
•
Refer to P94 for details.
[EXPO.METER]
•
Set to [ON] to display the [EXPO.METER] when correcting exposure,
performing Program Shift, setting aperture, and setting shutter speed.
•
Unsuitable areas of the range are displayed in red.
•
When [EXPO.METER] is not displayed, switch the display information
for LCD monitor/viewfinder by pressing [DISPLAY]. (P63)
•
The [EXPO.METER] disappears after approximately
4 seconds if no operation is performed.
[EXPO. SETTINGS]
Setting items for each [REC] Mode
³
Program Shift
±
´
Shutter speed
²
Shutter speed
•
You cannot switch between LCD monitor and viewfinder by pressing [LVF/LCD] when it is set to
[SWITCH BY PRESSING THE LVF/LCD BUTTON].
•
[EXPO. SETTINGS] is disabled when you set [AUTO SWITCH] in [LVF/LCD SWITCH] to [OFF].
132
VQT3A36
This will set the operation of the [
preview screen.
[OFF]: Preview screen is displayed only when the [
pressed.
It will return to previous screen when [
[ON]: Preview screen is displayed even after the [
released after pressing. (P95)
It will return to previous screen when [
again.
[OFF]/[ON]
Select whether or not to display the exposure meter when the mode dial is
³
switched to /
[OFF]/[ON]
Change the method of Exposure Compensation setting switching
when the mode dial is set to
[SWITCH BY PRESSING THE REAR DIAL]
Press the rear dial to switch between Exposure Compensation,
Program Shift, aperture setting, and shutter speed setting.
[SWITCH BY PRESSING THE LVF/LCD BUTTON]
Press [LVF/LCD] to switch between Exposure Compensation,
Program Shift, aperture setting, and shutter speed setting.
Aperture
± ´ ²
/ / etc.
,
Exposure Compensation
Exposure Compensation
Exposure Compensation
Aperture
] button when displaying the
, and .
:
:
or
] is
] is released.
] is
] is pressed