16
Installing the Hardware and Software
3
4
Use the supplied Power Extension Cable to connect the
FireGL™ card to the computer's hard drive power connector.
1
2
3
Remove any existing graphics card from your
computer.
•
Unscrew the screw attached to your existing
graphics card. Then pull the card straight out.
•
If the old graphics card sticks rock it gently from
end to end. Remember to save the screw.
•
If your computer has any on-board graphics
capability, you may need to disable it on the
motherboard. Refer to your computer's manual
for more information.
Connecting power to the card
The FireGL™ card requires connection to your
PC's internal power supply for operation. A 300W
power supply or greater is recommeded to ensure
normal operation where a number of other internal
devices are installed.
Remove the power cable from the hard drive power
connector.
Connect A of the Power Extension Cable to the FireGL
card as shown. (the cable may already be connected to the
graphics card.)
Connect B to the power supply connector