Hard Drive - HP 600 Maintenance And Service Manual

Remove the hard drive blank.
2.
To replace the blank, slide the blank into the bay until it locks into place.

Hard drive

CAUTION:
unless all bays are populated with either a component or a blank. Remove a drive only when
there is another drive ready to install or the MDS600 is powered down.
Before replacing a hard drive, do the following:
•
Verify the status of the drive to be replaced by reviewing the SAS and SATA hard drive LEDs (on page
58) and SAS and SATA hard drive LED combinations (on page 59).
•
Check the RAID status and configuration to be sure data loss will not occur if the drive is removed. For
more information, see the HP Array Configuration Utility User Guide on the HP website
(http://www.hp.com).
•
Be sure that the replacement hard drive is the same interface and the same or larger capacity.
To remove the component:
Extend the hard drive drawer (on page 25).
1.
CAUTION:
they were removed from.
To prevent improper cooling and thermal damage, do not operate the MDS600
To avoid data loss, be sure that the drives are labeled and returned to the same bays
Removal and replacement procedures 27