HP 600 Maintenance And Service Manual page 49

CAUTION: To avoid damage to the equipment, be sure that the cables are properly connected.
The red cable is 12V. The black cable is GND.
Install the backplane board:
2.
Be sure the board is lined up on the standoffs.
a.
Install the screws.
b.
Connect the LED panel cable.
3.
Install the cover.
4.
Install the cable management arm.
5.
Install the hard drive drawer.
6.
Install the hard drives.
7.
Close the hard drive drawer.
8.
Install all rear panel components.
9.
Connect the cables.
10.
Removal and replacement procedures 49