Hard Drive Drawer - HP 600 Maintenance And Service Manual

Hard drive drawer

To remove the component:
Power down the MDS600
1.
Disconnect all cables.
2.
Remove all power supplies
3.
Remove all fan modules ("Fan" on page 31).
4.
Remove all hard drives
5.
CAUTION:
they were removed from.
Be sure the hard drive drawer is closed completely.
6.
Remove all I/O modules
7.
Pull down the handle on the front of the drawer, but do not extend the drawer.
8.
Push up and hold the two release mechanisms on the I/O bays, and then push the drawer forward
9.
about 15 cm (6 in).
WARNING:
not extend the hard drive drawers beyond the supporting surface when the unit is not installed in
a rack.
WARNING:
one hard drive drawer is extended at a time.
WARNING:
• Never reach inside the chassis while the system is powered up.
Perform service on system components only as instructed in the user documentation.
•
Remove the power block
10.
("Power down" on page 25).
("Power supply" on page 34).
("Hard drive" on page 27).
To avoid data loss, be sure that the drives are labeled and returned to the same bays
("Hot-plug I/O module" on page 32).
TIP HAZARD! To reduce the risk of personal injury or damage to the equipment, do
To reduce the risk of personal injury or damage to the equipment, ensure that only
To reduce the risk of electric shock or damage to the equipment:
("Power block" on page 40).
Removal and replacement procedures 36