Advertisement
Before
Setting
Oven Controls
(conrd)
About
the Ceramic
Glass Cooktop
The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element underneath. Be sure to match the pan size with the diameter of the
element outline on the cooktop. Heat is transferred up through the surface of the cooktop to the cookware. Only flat-
bottomed cookware should be used,
The type and size of cookware, the number of surface elements in use and their settings, are all factors that will affect the
amount of heat that will spread to areas beyond the surface elements. The areas surrounding the elements may become
hot enough to cause burns.
EL[MENT ON
0
,/:
::
TR PLE
000
000
000
ELEMENT
0
0
O
0
0
•
/
ON_OF_
WARMER
ZONE
RIGHT
REAR
RIGHT
FRONT
Warmer
Zone
Single
Radiant
Surface
Control
Surface
Control
(some models)
Triple
Element
Surface
Control
About
the Radiant
Surface
Elements
The element temperature rises gradually and evenly.
As the temperature rises, the element will glow red.
To maintain the selected setting, the element will
cycle on and off. The heating element retains
enough heat to provide a uniform and consistent
heat during the off cycle.
For efficient cooking, turn off the element several
minutes before cooking is complete. This will allow
residual heat to complete the cooking process.
NOTE: Please read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning and Before
You Call checklist sections of this Use & Care Guide.
NOTE: Radiant elements have a limiter that allows the element to cycle ON and OFF, even at the HI setting. This helps to
prevent damage to the ceramic smooth top. Cycling at the HI setting is normal and will occur more often if the cookware
is too small for the radiant element or if the cookware bottom is not flat.
HOTSURFACE
OO0
O
O
RIGHT REAR
Rl(
ELEMENT
ON and Hot Surface
Indicator
Lights
Your range is equipped with two different types of radiant surface control
indicator lights that will glow on your range-- the ELEMENT ON
indicator light and the Hot Surface indicator lights (See illustration at
left). The ELEMENT ON located on the control panel and will glow when
a surface element is turned ON. A quick glance at this indicator light
after cooking is an easy check to be sure ALL surface controls are
turned OFF.
The Hot Surface indicator lights located above each surface
radiant
control
knob will glow as the surface cooking area heats up and will
REMAIN ON until the glass cooktop has cooled to a MODERATE level,
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon
holders or plastic wrappings
on
top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.
Do not allow aluminum
foil, empty glass/porcelain
cookware
or ANY material that can melt to
make contact with the ceramic
cooktop.
If these items melt on the cooktop they WILL damage the ceramic cooktop.
Advertisement
