Brother HL-5470DW Quick Setup Manual page 24

For Wireless Network Users
One push setup using WPS (Wi-Fi Protected Setup) or AOSS™
(Windows
11
Configure the wireless
settings
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your wireless access point/router.
If you began the wireless setup from step 5 on
page 5, go to d.
All other users, go to c.
c
On your machine, press a or b to choose
Network and press OK.
Press a or b to choose WLAN and press OK.
d
Press a or b to choose WPS/AOSS and press
OK.
When WLAN Enable? is displayed, press a to
accept. This will start the wireless setup wizard.
Otherwise press Cancel to exit from the
wireless setup wizard.
e
When Press Key on rtr appears, press
the WPS or AOSS™ button on your wireless
access point/router. See the user's guide for
your wireless access point/router for
instructions. And then press a.
This feature will automatically detect which
mode (WPS or AOSS™) your wireless access
point/router uses to configure your machine.
24
®
and Macintosh)
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Configuration using the
PIN Method of WPS (Wi-Fi Protected Setup) in
the Network User's Guide.
f
A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 25.
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your wireless access
point/router.
To install the printer driver, continue to
step 12.
®
For Windows Users:
Now go to
page 28
For Macintosh Users:
Now go to
page 30