Brother HL-5470DW Quick Setup Manual page 21

For Wireless Network Users
h
Check Yes if you want to connect with the listed
SSID. Click Next and go to k.
i
The wizard will search for wireless networks
available from your machine. Choose the SSID
that you wrote down for your network in step
10-a on page 18, and then click Next.
Note
• If the list is blank, check that the wireless access
point/router has power and is broadcasting the
SSID, and then see if the machine and the
wireless access point/router are within range for
wireless communication. Then, click Refresh.
• If your wireless access point/router is set to not
broadcast the SSID you can manually add it by
clicking the Advanced button. Follow the
on-screen instructions for entering the Name
(SSID), and then click Next.
j
Enter the Network Key you wrote down in step
10-a on page 18, and then click Next.
Note
If your network is not configured for
Authentication and Encryption, the ATTENTION!
screen will appear. To continue configuration,
click OK.
k
Confirm the wireless network settings and then
click Next. The settings will be sent to your
machine.
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.
l
Disconnect the USB cable between the
computer and the machine and then click Next.
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your wireless access
point/router.
To install the printer driver, continue to
step 13-e on page 28.
Now go to
page 28
21