Oki CX2032MFP Safety And Warranty Manual page 11

Material Safety Data Sheet
MSDS #58385601
Yellow Toner: P/N 43324474
All Countries / Regions
For more information, contact Oki Data at: 2000 Bishops
Gate Boulevard, Mount Laurel, NJ 08054-4620.
Emergency Information: call 1-800-654-3282; US and
Canada only.
Emergency First Aid Procedures ______________
Toner swallowed (ingested)
Immediately seek medical attention. Never give anything
by mouth to an unconscious person. If possible, rinse out
mouth and give one or two glasses of water or milk to
drink.
Toner inhaled.
Remove person to fresh air. Seek medical attention.
Toner gets in the eyes.
Flush eyes with large quantities of cool water for 15
minutes, keeping the eyelids open with fingers. If
necessary, seek medical attention.
Toner gets on the skin.
Wash toner off the skin with plenty of cool water and soap.
If necessary, seek medical attention.
Note: Small amounts of toner on skin or clothing can
easily be removed with soap and cold water. Hot
water makes toner harder to remove.
Hazardous Ingredients _____________________
Silica dioxide (about 2% by weight)
CAS#: Trade Secret.
OSHA PEL: Not established.
ACGIH TLV: Not established.
LD : Not Available.
50
LC : Not Available.
50
Physical Data_____________________________
Physical State: Solid.
Melting/Freezing Point: Not available.
Boiling Point: Not available.
PH: Not available.
Vapor Pressure: Not available.
Vapor Density (Air=1): Not available.
Evaporation Rate (Butyl Acetate=1): Not available.
Specific Gravity (H O=1): 1.1 to 1.2 at 20°C (68°F).
2
Solubility in Water: Not available.
Solubility in Solvents: Some components are soluble in
toluene, chloroform and tetrahydrofuran.
Coefficient of water/oil Distribution: Not available.
Appearance and Odor: Yellow powder, no odor.
Odor Threshold: Not available.
Fire and Explosion Hazard Data_______________
Minimal fire hazard. Large quantities may cause risk of
dust explosion.
Flash Point (Method Used): Not applicable.
Flammable Limits
Lower Explosive Limit: Not available.
Upper Explosive Limit: Not available.
Auto-Ignition Temperature: Not available.
Explosion Data
Sensitivity to Mechanical Impact: Not available.
Sensitivity to Static Discharge: Not available.
Extinguishing Media: In case of small fire, use CO
case of large fire, shut off air by spraying with water or
foam.
Special Fire Fighting Procedures: Fight fire from
upwind position. Avoid inhalation of smoke or gases.
Wear self-contained breathing apparatus.
Hazardous Combustion Products: Carbon monoxide,
oxides of nitrogen.
Toxicological Properties _____________________
Routes of Entry: Inhalation, Ingestion, Eyes, Skin.
Effects of Acute Exposure: Not available.
Effects of Chronic Exposure: Not available.
Exposure Limits: Not available.
Irritancy: Not available.
Sensitivity: Not available.
Carcinogenicity
IARC: Silica Dioxide—Group 3. Not classifiable.
NTP: No components are listed.
OSHA: No components are listed.
Reproductive Toxicity: Not available.
Teratogenicity: Not available.
Mutagenicity: Not available.
Name of Toxicologically Synergistic Products: Not
available.
Reactivity Data____________________________
Stability: Stable in general.
Conditions to Avoid: Avoid excess heat and all sources
of ignition.
Polymerization: Will not occur.
Hazardous Decomposition or Byproducts:
Combustion products include harmful gases such as
carbon monoxide and nitrogen oxides.
Incompatibility: Not available.
Preventive Measures _______________________
Personal Protective Equipment
Respiratory Protection: Not normally required. For
large spills, use dust respirator during cleanup.
Protective Gloves and/or Eye Protection: Not
normally required. For large spills, use rubber gloves and
safety goggles during cleanup.
Engineering Controls
Ventilation: Outside of normal ventilation, not normally
required.
Other Protective Equipment and/or Hygienic
Practices: None.
Spill Cleanup
Small Spills
1. Remove sources of ignition.
2. Carefully clean up the spill with a wet cloth, avoiding
inhalation of fine dust.
11 - English
. In
2