Table of Contents
Advertisement
P4TDH BIOS Setup
For example: If set to "Former-Sts" and AC power is lost when system is live, then after
AC power is restored, the system will automatically power on. If AC power is lost when
system is not live, system will remain powered off.
CPU THRM-Throttling
Select the CPU THRM-Throttling rate.
The Choices: 87.5%, 75.5%, 62.5%, 50.0% (default), 37.5%, 25%, 12.5%.
Wake-Up/Power On Control
If you highlight the literal "Press Enter" next to the "Wake-Up/ Power On Control" lable
and then press the enter key, it will take you a submenu with the following options:
Wake-Up by PCI card
When you select Enable, a PME signal from PCI card returns the system to Full
On state.
The Choices: Enabled (default), Disabled.
Power On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
The Choices: Enabled (default), Disabled.
Wake Up On LAN
To use this function, you need a LAN add-on card which support power on
function. It should also support the wake-up on LAN jumper.
The Choices: Enabled (default), Disabled.
USB KB Wake-Up From S3
This item allows you to enable/ disable USB KB wake up from S3.
The Choices: Disabled (default), Enabled.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During
Disabled, you cannot use this function. During Enabled, Choose the Date and
Time.
Alarm:
Note:
Date (of Month) Alarm
the system will boot up.
Time (hh:mm:ss) Alarm
minute and second the system will boot up.
If you have change the setting, you must let the system boot up
until it goes to the operating system, before this functin will
work.
22
You can choose which month
You can choose shat hour,
Advertisement
Table of Contents
