Pcie Frequency [Auto]; Dram Frequency [Auto]; Dram Timing Control [Auto] - Asus Blitz Extreme User Manual

Ratio CMOS Setting [7]
Configuration options: [6] [7]
The following two items only appear when you set the Ai Overclocking item to
[Manual].
FSB Frequency [266]
Displays the frequency sent by the clock generator to the system bus and PCI bus.
The value of this item is auto-detected by the BIOS. Use the <+> and <-> keys to
adjust the FSB frequency. You can also type the desired CPU frequency using the
numeric keypad. The values range from 200 to 800. Refer to the table below for
the correct Front Side Bus and CPU External Frequency settings.
FSB/CPU External Frequency Synchronization
Front Side Bus
Refer to page 2-3 for FSB frequency LED definition.

PCIE Frequency [Auto]

Allows you to set the PCI Express frequency.
Configuration options: [Auto] [100] [101]~[149] [150]

DRAM Frequency [Auto]

Allows you to set the DDR3 operating frequency.
Configuration options: [Auto] [DDR3-800MHz] [DDR3-889 MHz] [DDR3-1067MHz]
A very high DRAM frequency may cause the system to become unstable! If this
happens, revert to the default setting.

DRAM Timing Control [Auto]

Configuration options: [Auto] [
The following items appear when you set the DRAM Timing Control item to
[Manual].
CAS# Latency [ 6]
Configuration options: [5] [6] [7] [8] [9] [10]
RAS# to CAS# Delay [ 5 DRAM Clocks]
Configuration options: [3 DRAM Clocks] [4 DRAM Clocks]~[9 DRAM Clocks]
[10 DRAM Clocks]
4-18
CPU External Frequency
FSB 1333
FSB 1066
FSB 800
Manual
333 MHz
266 MHz
200 MHz
]
Chapter 4: BIOS setup