Table of Contents
Advertisement
•
For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 400 W.
•
Do not forget to connect the 4-pin/8pin EATX12V power plug; otherwise,
the system will not boot.
•
Use of a PSU with a higher power output is recommended when
configuring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
•
The ATX 12 V Specification 2.0-compliant (400W) PSU has been tested
to support the motherboard power requirements with the following
configuration:
CPU: Intel
Memory: 512 MB DDR2 (x4)
Graphics card: ASUS EAX1900XT
Parallel ATA device: IDE hard disk drive
Serial ATA device: SATA hard disk drive (x2)
Optical drive: DVD-RW
•
If you want to use two high-end PCI Express x16 cards, use a PSU with
500W to 600W power or above to ensure the system stability.
10. Digital audio connector (4-1 pin SPDIF, for ASUS HDMI VGA card)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF)
port(s). If you are using ASUS HDMI-equipped graphics card, connect the
HDMI card to this connector with a S/PDIF out cable.
BLITZ EXTREME
BLITZ EXTREME Digital audio connector
The ASUS HDMI-equipped graphics card and S/PDIF out cable are purchased
separately.
ASUS Blitz Extreme
Pentium
Extreme 3.73GHz
®
®
SPDIF_OUT
GND
SPDIFOUT
+5V
2-35
Advertisement
Table of Contents
