Table of Contents
Advertisement
2.
Serial ATA connectors (7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
drives and optical disk drives. The Serial ATA 3Gb/s is backward compatible with the
Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster
than the standard parallel ATA (133 MB/s).
AT4NM10-I SATA connectors
Install the Windows
3.
USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
This USB connector complys with USB 2.0 specification that supports up to 480 Mbps
connection speed.
AT4NM10-I USB2.0 connectors
Never connect a 1394 cable to the USB connector. Doing so will damage the motherboard!
The USB module cable is purchased separately.
1-13
XP Service Pack 2 or later versions before using Serial ATA.
®
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
