Oven - Maytag MMV5165BAW - 1.6 cu. Ft. Microwave Installation Instructions Manual

Over the range microwave oven
Hide thumbs Also See for MMV5165BAW - 1.6 cu. Ft. Microwave:
Table of Contents

Advertisement

Installation
Instructions
7. Secure the blower
unit to the microwave
with the
two screws
removed
in Step 2.
sRce t eawn i_
_
__
__
etaining
screw
8. Close
the blower
cover
and secure
it with the
screw removed
in Step 1.
9. Attach the exhaust
adaptor
to the rear of the
microwave
by sliding it into the guides
at the top
center of the back of the oven.
Back of
Microwave
CHECK FOR PROPER DAMPER
OPERATION
Exhaust
Adaptor
(absent on models
shipped
for recirculation
exhaust)
-
Damper
Place
the microwave
in its upright
position,
with
the top of the unit facing
up.
This microwave
oven
may be shipped
assembled
for top exhaust
(adaptor
installed)
or
for recirculation
exhaust
(adaptor
absent).
Make sure tape securing
damper
is removed
and damper
pivots easily before
mounting
microwave.
You will need to make adjustments
to assure
proper alignment
with your house exhaust
duct
after the microwave
is installed.
MOUNT THE MICROWAVE
OVEN
FOR EASIER
INSTALLATION
AND PERSONAL
SAFETY,
WE RECOMMEND
THAT TWO PEOPLE
INSTALL
THIS MICROWAVE
OVEN.
IMPORTANT:
Do not grip or use handle
during
installation.
NOTE:
If your cabinet is metal, use the nylon
grommet
around the power cord hole to prevent
cutting of the cord.
NOTE:
We recommend
using filler blocks
if the
cabinet front hangs below the cabinet
bottom shelf.
IMPORTANT:
If filler
blocks
are not used, case
damage
may occur
from
over tightening
screws.
NOTE:
When mounting
the microwave
oven, thread
power cord through
hole in bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch cord
or lift oven by pulling cord.
1. Lift microwave,
tilt it
forward,
and hook slots
at back bottom
edge
onto four lower tabs of
mounting
plate.
2.
Rotate front of oven up
against cabinet
bottom
__
3.
Insert a self-aligning
screw through
top left
cabinet
hole. Temporarily
secure the oven by
turning the screw at least two full turns
after the
threads
have engaged.
(It will be completely
tightened
later.) Be sure to keep power
cord
tight.
Be careful
not to pinch
the cord,
especially
when
mounting
flush
to bottom
of
cabinet.
16

Advertisement

Table of Contents
loading

Table of Contents