Table of Contents
Advertisement
Installation
Instructions
C2.__. ATTACH THE MOUNTING
PLATE
TO THE WALL (cont.)
To use toggle bolts"
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
I Toggle Wings
Belt End
3.
Place the mounting
plate against
the wall and
insert the toggle wings into the holes on the wall to
mount the plate.
NOTE:
Before tightening
toggle
bolts and wood
screw, make sure to coincide
bottom
line of the
Mounting
plate with Horizontal
line of "Rear wall
Template"
and then the Mounting
plate is properly
centered
under the cabinet.
CAUTION:
Be careful to avoid pinching
fingers
between
the back of the mounting
plate and the wall.
4. Tighten
all bolts. Pull the plate away from the wall
to help tighten the bolts.
C3. USE TOP CABINET
TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough
for the power
cord to fit through.
•
Read the instructions
on the TOP CABINET
TEMPLATE.
•
Tape it underneath
the top cabinet.
•
Drill the holes, following
the instructions
on the
TOP CABINET
TEMPLATE.
CAUTION:
Wear safety goggles
when drilling holes in
the cabinet bottom.
C4. ADAPTING
MICROWAVE
BLOWER
FOR OUTSIDE
BACK
EXHAUST
1. Remove
the back top center blower
motor door
retaining
screw.
Blower
Back of
Blower Motor
Screw
2.
Open the blower motor by lifting it up at the back
side of the microwave.
Remove
and save the top
and back retaining
screws that hold the blower
motor in the microwave.
Retaining
Screw
/
Retaining
Screw
3.
Carefully
slide the blower motor toward the right,
and lift it partially out of the opening.
Note: The
blower wires are long enough
to allow flexible
handling
while performing
these steps.
Disconnect
the wires if necessary
for additional
flexibility.
/
4.
Remove
the two screws holding the left side inlet
sleeve to the blower
unit. Snap the inlet sleeve
off of the blower.
Remove_
screws
19
Advertisement
Table of Contents
