Table of Contents
Advertisement
Control buttons of the Settings for scheduled scan dialog
There are two control buttons available on all three tabs of the Settings for
scheduled scan dialog (Schedule settings,
these have the same functionality no matter on which tab you currently are:
· Save - saves all changes you have performed on this tab or on any other tab
of this dialog and switches back to the
Therefore if you wish to configure the test parameters on all tabs, press the
button to save them only after you have specified all your requirements.
· Cancel - cancels any changes you have performed on this tab or on any other
tab of this dialog and switches back to the
dialog.
11.5.2. How to Scan
On the How to scan tab you will find a list of scanning parameters that can be
optionally switched on/off. By default, most parameters are switched on and the
functionality will be applied during scanning. Unless you have a valid reason to change
these settings we recommend to keep to the pre-defined configuration:
· Automatically heal/remove infection - if a virus is identified during scanning
it can be healed automatically if a cure is available. In case the infected file
cannot be healed automatically, or if you decide to switch off this option, you
will be notified upon a virus detection and will have to decide what to do with
A V G 9 .0 File Server © 2 0 1 0 C opyright A V G T ec hnologies C Z, s .r.o. A ll rights res erved.
How to scan
and
What to
AVG scanning interface default
AVG scanning interface default
scan) and
dialog.
1 0 6
Advertisement
Table of Contents
Need help?
Do you have a question about the AVG 9.0 FILE SERVER - V 90.8 and is the answer not in the manual?
Questions and answers