Tandberg Data MSERIES Installation Manual page 40

Tandberg Data M-Series Installation Guide
Document T6423046-02 A01
February 2004
Figure 37 Removing the
Level 1 Left Magazine
40
3 Remove each remaining magazine by grasping the handle at the front of
the magazine and sliding it forward and out of the library.
4 Insert cleaning cartridges into the fixed slots.
There is one fixed slot behind each left magazine.
Note:
Orient the cartridges with the label facing outward and the write-protect
switch:
• Down, if it is a DLT or SDLT cartridge
• Up, if it is an LTO cartridge
5 Insert cartridges into each of the magazine slots (see
Orient the cartridges as described in
a
Push each cartridge into a slot until the cartridge retaining latch clicks
b
to hold the cartridge in place.
The magazines are designed so that you cannot insert
Caution:
cartridges incorrectly. Do not force the cartridges into the
slots.
6 Insert the magazines into the library, sliding them back until they click
into place.
7 Close the magazine access doors.
Preparing and Inserting Tape Cartridges
figure 34):
step 4.