Tandberg Data MSERIES Installation Manual page 26

Tandberg Data M-Series Installation Guide
Document T6423046-02 A01
February 2004
Figure 23 Installing the
Rear Shelf Clamps
26
7 Install the clamp strips (see
Position a front shelf clamp (PN 215812) at the front of the front left
a
rack rail, with the bottom of the clamp approximately 15.5 inches (394
millimeters) above the bottom of the rack mount shelf.
The top of the front shelf clamp must be no more than 580
Caution:
mm above the bottom of the rack mount shelf.
Position a clamp strip (PN 217405) behind the front left rack rail,
b
aligning it with the shelf clamp.
Insert a screw (PN YS42064) through the upper hole in the front shelf
c
clamp, through the rack rail, and into the upper hole in the clamp
strip.
Insert a screw (PN YS42064) through the bottom hole in the front
d
shelf clamp, through the rack rail, and into the bottom hole in the
clamp strip.
Repeat steps 7a through
e
strip on the right rack rail.
Installing a Rack Mount Library
figure 24):
7d to install the front shelf clamp and clamp