Tandberg Data MSERIES Installation Manual page 38

Tandberg Data M-Series Installation Guide
Document T6423046-02 A01
February 2004
Figure 34 Inserting DLT
Cartridges into a Magazine
38
Label Write-protect
5 Insert the magazines into the library, sliding them back until they click
into place.
6 Close the magazine access doors.
Placing Tape Cartridges in an M2500
To place tape cartridges in an M2500:
1 Press the buttons next to the magazine access doors.
The magazine access doors open.
2 Remove the level 1 left magazine:
Grasping the handle at the front of the level 1 left magazine, pull it
a
forward until it stops.
If the magazine stops after the first slot, perform steps
b
to release it.
Remove the level 2 left magazine (see
c
Preparing and Inserting Tape Cartridges
Cartridge
retaining latch
switch
figure
0
2c through 2e
35).