Tandberg Data MSERIES Installation Manual page 15

Table 5 Shelf Assembly
Matrix
Assembling the Rack Mount Shelves
To assemble the rack mount shelves:
1 Measure the distance between the inside surfaces of the front and rear
rack rails, then find the corresponding rack depth in
2 Assemble the left shelf:
Refer to the
a
Left Shelf/Shelf Extender
which shelf extender to combine with the left universal shelf.
Insert the posts on the left universal shelf into the shelf extender slots
b
identified in the
The slots in the shelf extenders are identified as shown in
Use the M5 nuts (PN YS41998) and M5 washers (PN YS40403)
c
provided in the rack mount kit to fasten the left shelf and shelf
extender together (see
Tighten the nuts to finger-tightness only; you need to be able
Note:
to retract and extend the assembled shelves slightly.
3 Assemble the right shelf in the same manner, referring to the
column of table 5.
Rack Depth
(between flanges)
24.25 in. to 26.75 in.
(617 mm to 680 mm)
26.75 in. to 29.125 in.
(680 mm to 740 mm)
29.125 in. to 31.5 in.
(740 mm to 800 mm)
31.5 in. to 33.875 in.
(800 mm to 860 mm)
33.875 in. to 36.25 in.
(860 mm to 920 mm)
Installing a Rack Mount Library
Tandberg Data M-Series Installation Guide
column of
column of
Left Shelf/Slots
figure 12).
Left Shelf
Shelf
Extender Slots
Long #2 A & B
Long #1 B & C
Long #2 B & C
Long #1 C & D
Long #2 C & D
Document T6423046-02 A01
February 2004
table 5.
table 5 to determine
table 5.
figure 11.
Right Shelf
Right Shelf
Shelf
Extender Slots
Long #1 A & B
Long #2 A & B
Long #1 B & C
Long #2 B & C
Long #1 C & D
0
15