Electrical Requirements; Connecting Electric Dryers - Kenmore 8885 - Rear Control 7.3 cu. Ft. Capacity Electric Dryer Use & Installation Instructions Manual

ELECTRICAL REQUIREMENTS
CONNECTING ELECTRIC DRYERS
nr!_IWARNING: To help prevent fire, electric
shock, serious injury, or death, the wiring and
grounding must conform to the latest edition of
the National Electrical Code, ANSI/NFPA 70 and
all applicable local regulations. Please contact
a qualified electrician to check your home's wiring
and fuses to ensure that your home has adequate
electrical power to operate the dryer.
Special Electrical Requirements for Mobile
or Manufactured Homes
nr!,WARNING: To reduce the risk of fire,
|
electric shock, or injury to persons when using
this appliance, follow basic precautions, including
the following:
• Any installation in a manufactured or mobile home must
comply with the Manufactured Home Construction and
Safety Standards Title 24 CFR, Part 32-80 or Standard
CAN/CSAOZ240 MH and local codes and ordinances.
• A 4-wire connection is required for all mobile and
manufactured home installations, as well as all new
construction after January 1, 1996. Failure to do so
can result in fire, explosion, or death.
Electrical Requirements for
Electric Models Only
nr!IWARNING
:
To reduce the risk of fire,
electric shock, or injury to persons when using
this appliance, follow basic precautions, including
the following:
• This dryer must be connected to a grounded
metal, permanent wiring system, or an equipment-
grounding conductor must be run with the circuit
conductors and connected to the equipment-
grounding terminal or lead on the dryer. Failure
to do so can result in fire, explosion, or death.
• The dryer has its own terminal block that must be
connected to a separate 240 VAC, 60-Hertz, single-
phase circuit, fused at 30 amperes. The circuit must
be fused on both sides of the line. ELECTRICAL
SERVICE FOR THE DRYER SHOULD BE OF THE
MAXIMUM RATE VOLTAGE LISTED ON THE
NAMEPLATE. DO NOT CONNECT DRYER TO 110-,
115-, OR 120-VOLT CIRCUIT. Heating elements are
available for field installation in dryers which are to
be connected to an electrical service of a different
voltage than that listed on the rating plate. Failure
to follow these instructions can result in fire, explosion,
or death.
• If branch circuit to dryer is 15 ft. (4.5 m) or less in
length, use UL (Underwriters Laboratories) listed
No.-10 AWG wire (copper wire only), or as required
by local codes. If over 15 ft. (4.50 m), use UL-listed
No.-8 AWG wire (copper wire only), or as required
by local codes. Allow sufficient slack in wiring so
dryer can be moved from its normal location when
necessary. Failure to do so can result in fire, explosion,
or death.
• The power cord (pigtail) connection between wall
receptacle and dryer terminal block IS NOT supplied
with the dryer. Type of pigtail and gauge of wire
must conform to local codes and with instructions
on the following pages. Failure to follow these
instructions can result in fire, explosion, or death.
• A 4-wire connection is required for all new
construction after January 1, 1996. A 4-wire
connection must be used where local codes do
not permit grounding through the neutral wire.
Failure to do so can result in fire, explosion, or death.
11