Download  Print this page

Kenmore 6972 - 700 7.5 cu. Ft. Capacity Electric Dryer User Instructions page 4

User instructions
Hide thumbs

Advertisement

Your dryer must be properly installed and vented to achieve
maximum drying efficiency and shorten drying times. Use the
minimum recommended
installation clearances found in the
Installation Instructions. See the Installation Instructions for more
information.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow
these instructions can result in death
or fire.
If the dryer is not properly installed and vented, it will not be
covered under the warranty. Proper venting of your dryer is
important for satisfactory
drying results. See the Installation
Instructions for more detail.
NOTE: Service calls caused by improper venting will be paid for
by the customer, whether it was a paid installation or self-
installed.
f.
Do not use plastic vent or metal foil vent. Use 4" (10.2 cm)
metal or flexible metal vent. Do not kink or crush flexible
metal vent. It must be completely extended to allow adequate
exhaust air to flow. Check vent after installation. Refer to the
Installation Instructions for proper length requirements of
vent.
2. Use a 4" (10.2 cm) exhaust hood.
3.
Use the straightest
path possible
when routing the vent.
Good
Better
4.
5.
Use clamps to seal all joints. Do not use duct tape, screws or
other fastening devices that extend into the interior of the
vent to secure vent.
Clean exhaust vent periodically, depending
on use, but at
least every 2 years, or when installing your dryer in a new
location. When cleaning is complete, be sure to follow the
Installation Instructions supplied with your dryer for final
product check.

Hide quick links:

Advertisement

loading

  Also See for Kenmore 6972 - 700 7.5 cu. Ft. Capacity Electric Dryer

  Related Manuals for Kenmore 6972 - 700 7.5 cu. Ft. Capacity Electric Dryer

This manual is also suitable for:

110.6752260011067741600