Maintenance Messages; Call Service Messages - Brother HL 5280DW - B/W Laser Printer User Manual

Error message (Continued)
Error message
NO PAPER XXX
NO TRAY XXX
PRINT OVERRUN
SIZE ERROR DX
SIZE MISMATCH
STORAGE FULL
TOO MANY TRAYS

Maintenance messages

Maintenance message
DRUM NEAR END
TONER LOW
TONER LIFE END
REPLACE PF KITMP
REPLACE PF KIT 1
REPLACE PF KIT 2
REPLACE PF KIT 3
REPLACE FUSER
REPLACE LASER

Call service messages

Call service message
ERROR ###
Action
Put paper in the empty tray.
Put the paper tray in the printer.
Cut the resolution or add the optional memory. See Installing extra memory on page 71 and
Solving print problems on page 111.
Set Page Protection to the correct size. See Device Options on page 31 and Menu table
on page 56.
You can only use A4, Letter and Legal size for duplex printing. Check the printer driver
setting and put the correct sized paper in the paper tray or MP tray that is selected in the
printer driver. See About paper on page 6.
Put the same size paper in the paper tray or MP tray that is selected in the printer driver,
and then press Go, or select the size of paper you set in the TRAY SIZE setting from the
control panel.
The RAMDISK size is set to 0 MB. Increse the RAMDISK size. Or there is no space to store
jobs. Delete unnecessary macros or fonts.
Maximum number of optional trays is two. Remove additional trays.
Action
The drum unit is near the end of its life. Buy a new drum unit to replace the current one.
See DRUM NEAR END message on page 80.
Buy a new toner cartridge and have it ready before you get a TONER LIFE END
message.
See Replacing the toner cartridge on page 75.
Call your dealer or Brother Customer Service for a replacement paper feeding kit (paper
pick up roller and separation plate) for the MP tray.
Call your dealer or Brother Customer Service for a replacement paper feeding kit (paper
feed roller, separation roller, separation pad, and separation pad spring) for Tray 1.
Call your dealer or Brother Customer Service for a replacement paper feeding kit (paper
feed roller, separation roller, separation pad, and separation pad spring) for Tray 2.
Call your dealer or Brother Customer Service for a replacement paper feeding kit (paper
feed roller, separation roller, separation pad, and separation pad spring) for Tray 3.
Call your dealer or Brother Customer Service for a replacement fuser unit.
Call your dealer or Brother Customer Service for a replacement laser unit.
Action
Turn off the printer. Wait a few seconds, then turn it on again. If this does not clear the
problem, call your dealer or a Brother Customer Service.
7. Troubleshooting
93