Lcd Messages - Brother HL 5280DW - B/W Laser Printer User Manual

LCD messages

If any problems occur, the printer automatically stops printing, diagnoses the problem, and displays the
resulting message on the LCD to alert you. Use the table below to identify and clear the error message. If you
cannot clear the problem, call the dealer you bought the printer from or Brother Customer Service.
Note
The LCD names for the paper trays are as follows.
• Standard paper tray: TRAY1
• Multi-purpose tray: MP
• Optional Lower tray: TRAY2 or TRAY3
Error message
Error message
BUFFER ERROR
CARTRIDGE ERROR
DIMM ERROR
DOWNLOAD FULL
DUPLEX DISABLED
DUST ON DRUM
FONT FULL
FRONT COVER OPEN
FUSER COVER OPEN
JAM XXX
MANUAL FEED
MEMORY FULL
NO PAPER
Action
Check the Interface settings.
Take out the drum unit assembly and put it back into the printer again.
Re-install the DIMM correctly.Turn off the printer. Wait a few seconds, and then turn it on
again. If this error message appears again, replace the DIMM with a new one.
Add more memory. See Installing extra memory on page 71.
Close the back cover of the printer and put the duplex tray back in.
Open the front cover. Take out the drum unit and toner cartridge assembly. Gently slide the
blue tab of the drum unit across several times.
Add more memory. See Installing extra memory on page 71.
Close the front cover of the printer.
Close the fuser cover located behind the back cover of the printer.
Carefully pull out the jammed paper from the area shown in Paper jams and how to clear
them on page 96.
Put the same size of paper in the MP tray as is shown on the LCD. If the printer is 'paused',
press Go.
Add more memory. See Installing extra memory on page 71 and Solving print problems on
page 111.
Put paper in the empty tray. If the error was not cleared when you put paper in the tray,
match the size of the paper that you selected in the application with the TRAY SIZE or set
the TRAY SIZE to ANY using the control panel.
7. Troubleshooting
92