Table of Contents
Advertisement
For example, suppose you like classical music with a flat sounding tone.
The station has already been preset to pushbutton
3. Since the flat
response is on button C, you would just:
1
1. Press the preset pushbutton 3.
2. Next, press the tone control button C.
3. Then, press the SET button.
4. Press the tone control button C again.
5. Press the preset pushbutton 3 again and your Preset Equalization is set
Now every time you press the preset pushbutton 3, the Preset
Equalization tone is programmed to that preset pushbutton. Tuning to the
station already preset to 3 using the h o b , or SEEK or
SCAN,
the tone
control will automatically change to C. The Preset Equalization button
will light when it is programmed to a particular pushbutton or when
manually pushed
in.
in memory.
Playing a Cassette Tape
Your cassette tape player works best with tapes that are 30 to 45 minutes
long on each side. Tapes longer
than that are
SQ
thin that they may not
work well in this player.
1. Turn the radio on.
2. Insert the cassette squarely through the tape door. (TP will appear in
the display.)
I
If you hear nothing or hear just a garbled sound, the cassette may not be
in squarely. Press the EJECT button to remove the tape and start over.
The tape equalization is automatically sensed and set. Inserting the
cassette also automatically disables DNR@ and activates Dolby@ noise
reduction. DNR@ is a registered trademark of National Semiconductor
Corporation.
3-12
Advertisement
Table of Contents
