Advertisement
Why My Remote Shifter Doesn't Work Properly?
You may have a shifting problem that you cannot set at L or H position properly due to the lengthened inner
cable. To fix this problem, follow the steps to adjust the initial cable tension.
Set your remote shifter at "H" position and remove the shifter from your handlebar, then straighten the
1.
cable as much as possible.
Pull out the plastic cover cap on foot of the remote cable. (see Fig. R)
2.
Hold the inside adjusting screw and push it toward the shifter, then adjust the locking nut to set the cable
3.
tension properly. (see Fig. S)
Install the cover cap again.
4.
Adjusting Screw
Cap
How To Use Small Wheel Adaptor
If you wish to use the tire sized 24 x 1.75" or smaller,
you need to install the supplied Z-shaped "Small
Wheel Adapter" between Base Plate and Mag unit to
raise up the roller height.
The direction of Z-adapter is fixed so follow the
arrow printed on the top and make sure it's pointing
toward the front (toward your bike).
If the drive roller cannot reach the tire even if you
install the adaptor, make sure you have been installed
in correct direction.
Use the original cap head bolts for Base Plate, and
use the supplied hex head bolts for the Mag unit.
Lock Nut
(Fig. R)
Required Tools:
Z-Adaptor
Hex Head Bolt
Cap Head Bolt
- Page 8 -
Tighten Nut
1 x 10mm Spanner
1 x M5 Hex Wrench
(in case of V270)
(Fig. S)
Advertisement
