Toilet Model Identification; Toilet Operation - Dometic ECOVAC SANITATION SYSTEM Owner's Manual

TOILET MODEL IDENTIFICATION

The above label is located on the toilet base and will show the model number and serial number. If label is not
available, please refer to the Dimensional Specifications section for toilet model identification.

TOILET OPERATION

IMPORTANT INFORMATION BEFORE OPERATION
1. Fill freshwater tank and add deodorant to holding tank through toilet bowl.
(See System Start-Up section.)
2. Make sure all guests understand the operation of the EcoVac system and
the instruction label is in plain sight and easy for guests to read. If this
label is not included in this manual, please contact the SeaLand
Product Customer Service Department immediately.
3. Remember the vacuum pump starts automatically. Shut off the system before servicing and do not leave the
boat with toilet system breaker on.
4. Never use drain openers, alcohol, solvents, etc. in the system.
5. If the system does not function properly, refer to the Troubleshooting section of this manual and repair as
necessary. If problem persists, contact your local SeaLand product dealer.
SYSTEM START-UP
1. Turn on electrical power to system.
2. Flush water into system by depressing flush lever until water starts flowing to the vacuum pump, approximately
15 seconds. This wets the pump interior for efficient operation. If vacuum pump does not run, check for loose
electrical connections. Refer to the wiring diagram at the end of the Troubleshooting Guide section.
3. The vacuum pump will run for approximately 30 to 90 seconds until system reaches operating vacuum level and
then will shut off.
1. To add water to the toilet before
using, raise flush lever until desired
water level is reached. Generally, more
water is required only when flushing
solids.
NOTE: Make sure all guests understand the operation of the EcoVac toilet, and that the instruction label is easy to
read and in plain sight.
DOMETIC CORPORATION
P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886
BIG PRAIRIE, OH 44611 USA
000
MODEL NO.
SERIAL NUMBER
000000
NORMAL OPERATION
2. To flush toilet, press flush lever
sharply down to the floor until contents
clear bowl. A sharp popping noise is
normal when the vacuum seal is bro-
ken and flushing action begins. Be
sure to hold lever down for three (3)
seconds. If flush lever is accidentally
released before waste clears bowl, do
not attempt to flush toilet again until
vacuum pump stops running. A small
amount of water should remain in the
bowl after flushing.
4
3. Do not dispose of sanitary napkins
or other non-dissolving items in toilet,
such as facial tissue or paper towels.
These items can cause plugging of
the system.