Day/Night Mode; Set Home Address; Gps Status; Miles/Kilometre - Binatone F430 - EDITION 4 User Manual

4th edition
Hide thumbs Also See for F430 - EDITION 4:
Table of Contents

Advertisement

NAVIGATION
12:00 AM and an end time of between 1:00 till 12:00PM. Use the
and
buttons to select
the start and end time. This way you can customise the Day/Night Mode for any time of year.
Once set tap
to confirm the selection and return to the settings screen. Tap
to return
to the settings screen without saving.

8.6 Set Home Address

Allows you to set your home address so that it can be easily used when navigating. When tapped
you will be able to add a location from the options available when entering a destination under the
Go to section (see page 19). Note: the Go Home option will not be available.
If you need to change your home address at a later date, simply tap Set Home Address again to
re-enter your address.

8.7 GPS Status

When tapped the screen will change to the GPS
status screen, Note; this can also be brought up by
tapping
from any of the navigation screens.
This screen shows you information about your
current GPS position. Including the date & time,
your current speed, your current altitude above sea
level and your current position in Longitude and
latitude.
Included with this information is the number of satellites which you are currently locked on to. The
right half of the screen shows the position of these satellites in the sky. Each satellite will be
shown by a coloured circle; Orange means that the unit has locked on to the signal, while grey
means that the satellite has be found but the unit is not currently locked on to its signal. Each
satellite will be identified by a specific number shown inside the circle.
Note: In order to navigate you require that the unit is locked to 4 or more satellites and is referred
to as a 3D fix. The fix status will be shown above the circle on the right- Inactive means not fixed,
active means that a 3D fix has been obtained.

8.8 Miles/Kilometre

Tapping this option will change the units of distance; this
change will be reflected both on the map and in the voice
directions. Tap this option to change between Miles and
Kilometres. The currently selected option will be shown on the
screen.

8.9 About

Tapping this option will show you information relating to the version of navigation software you are
running.
8.10 Time Zone
Allows you to change the time zone so that the
time is always correct for the country you are in
There are two options to choose from; manually
and automatic.

Advertisement

Table of Contents
loading

Table of Contents