Day/Night Mode; Set Home Address; Gps Status - Binatone S500 User Manual

8.5 Day/Night Mode

Allows you to change the map so that the colour and brightness are optimal for driving in either
day time or night time conditions.
There are two options to choose from; manually and automatic.
Manually – when selected allows you to either
simply select day or night mode, by tapping either
or to make your selection.
This way you can customise the Day/Night Mode for any time of year.
Once set tap
to the settings screen without saving.

8.6 Set Home Address

Allows you to set your home address so that it can be easily used when navigating. When tapped
you will be able to add a location from the options available when entering a destination under the
Go to section (see page 19). Note: the Go Home option will not be available.
If you need to change your home address at a later date, simply tap Set Home Address again to
re-enter your address.

8.7 GPS Status

When tapped the screen will change to the
GPS status screen, Note; this can also be
brought up by tapping
navigation screens.
This screen shows you information about your
current GPS position. Including the date & time,
your current speed, your current altitude above
sea level and your current position in Longitude
and latitude.
Included with this information is the number of satellites which you are currently locked on to. The
right half of the screen shows the position of these satellites in the sky. Each satellite will be
shown by a coloured circle; Blue means that the unit has locked on to the signal, while grey means
that the satellite has be found but the unit is not currently locked on to its signal. Each satellite will
be identified by a specific number shown inside the circle.
to confirm the selection and return to the settings screen. Tap
from any of the
Automatic – When selected allows you to set a
start and end time, when the time is between
these two times the unit will be set to Day mode.
At all other times the unit will automatically switch
to Night mode. You can set a start time of
between 1:00 till 12:00 AM and an end time of
between 1:00 till 12:00PM. Use the
buttons to select the start and end time.
NAVIGATION
and
to return
43