Main Memory - Intel D865GBF Product Manual

Main Memory

NOTE
To be fully compliant with all applicable Intel
be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your
memory modules do not support SPD, you will see a notification to this effect on the screen at
power up. The BIOS will attempt to configure the memory controller for normal operation.
The desktop board supports system memory as defined below:
•
Dual channel and up to four 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory
Module (DIMMs) connectors with gold-plated contacts.
•
Supported memory configurations are:
Memory Speed
DDR400
DDR333
DDR266
•
Support for:
 Unbuffered, non-registered DIMMs
 Serial Presence Detect (SPD) memory only
 Support for Suspend to RAM (STR), S3 ACPI state
 Non-ECC DDR (ECC memory will run in non-ECC mode)
 2.5 V memory
NOTE
System resources (such as PCI and AGP) require physical memory address locations that reduce
available memory addresses above 3 GB. This may result in less than 4 GB of memory being
available to the operating system and applications.
Related Links:
Go to the following links or section in this manual for more information about:
•
the latest list of tested memory,
•
SDRAM specifications,
•
installing memory, page 34 in Chapter 2
Processor
Pentium 4 processor
Pentium 4 processor
Pentium 4 processor
Pentium 4 processor or
Celeron processor
Pentium 4 processor
Celeron processor
http://support.intel.com/support/motherboards/desktop/
http://www.intel.com/technology/memory/pcsdram/spec/
®
SDRAM memory specifications, the board should
Front Side Bus
Frequency
800 MHz
800 MHz
533 MHz
400 MHz
533 MHz or 400 MHz
400 MHz
Desktop Board Features
Memory Speed
Outcome
400 MHz
320 MHz
333 MHz
266 MHz
266 MHz
266 MHz
17