Bios Setup Configuration Jumper Block; Front Panel Audio Connector / Jumper Block (J6B2); Bios Setup Configuration Jumper Settings (J9G2) - Intel D815EEA2 Technical Product Specification

Table 51.

Front Panel Audio Connector / Jumper Block (J6B2)

Jumper Setting
9 7 5 3 1
10 6 4 2
5 and 6, 9 and 10
9 7 5 3 1
10 6 4 2
No jumpers installed
NOTE
When the jumpers are removed and this connector is used for front panel audio, the back panel
audio line out and Mic in connectors are disabled.

2.9.2 BIOS Setup Configuration Jumper Block

This 3-pin jumper block determines the BIOS Setup program's mode. Table 52 describes the
jumper settings for the three modes: normal, configure, and recovery.
When the jumper is set to configuration mode and the computer is powered-up, the BIOS compares
the CPU version and the microcode version in the BIOS and reports if the two match.
Table 52.

BIOS Setup Configuration Jumper Settings (J9G2)

Function/Mode
Normal
Configure
Recovery
For information about
How to access the BIOS Setup program
The maintenance menu of the BIOS Setup program
BIOS recovery
Configuration
Audio line out signals are routed to the back panel audio line out connector. The
back panel audio line out connector is shown in Figure 13 on page 64.
Audio line out and mic in signals are available for front panel audio connectors.
Table 30 on page 70 lists the names of the signals available on this connector
when no jumpers are installed.
Jumper Setting Configuration
The BIOS uses current configuration information and
3 1
1-2 passwords for booting.
After the POST runs, Setup runs automatically. The
3 1
2-3 maintenance menu is displayed.
The BIOS attempts to recover the BIOS configuration. A
1
3
None recovery diskette is required.
Technical Reference
Refer to
Section 4.1, page 111
Section 4.2, page 112
Section 3.7, page 106
83