GMC YUKON XL 2003 Manual page 439

To store the tools, follow these procedures:
For Tahoe/Yukon models do the following:
1. Put the tool kit, with the jack tools and gloves, in
the tool bag and place in the retaining clip above
the jack.
2. Tighten down with the wing nut.
3. Then, assemble wheel chocks and bottle jack
together with the wing nut and retaining hook.
4. Position behind the jack storage cover in the rear
access panel, and tighten, adjusting clockwise until
the jack is secured tight in the mounting bracket.
Be sure to position the holes in the base of the jack
onto the pin in the mounting bracket.
For SuburbanNukon XL models do the following:
1. Return the tool kit (jack tools and gloves) to the
tool bag.
2. Assemble wheel chocks and bottle jack together
with the wing nut and retaining hook.
3. Position under the jack storage tray in the left rear
side panel below the wheelbase and tighten,
adjusting clockwise until the jack is secured tight in
the mounting bracket. Be sure to position the
holes in the base of the jack onto the pin in the
mounting bracket.
4. Use the retaining clip to fasten the tool kit on the
stud in the storage compartment in the rear left
trim panel and turn the wing nut clockwise to
secure.
5. Return the storage tray.
TahoeNukon Models (Rear Access Panel)
A. Tool Kit with C. Wheel Block Wing Nut
B. Bracket and Wing Nut E. Jack
Jack Tools D. Tire Blocks
5-86