Compaq 12XL125 - Presario - K6-2 533 MHz Maintenance & Service Manual page 110

9. If the display data cable has the LVDS connector on the end as shown below, remove
the connector by
cable.
Ä Ä Ä Ä
CAUTION: For TFT displays, the connector on the end of the flex cable must be
removed before the cable can be routed through the slot on the upper CPU cover.
10. Gently pull the flex data cable and backlight cable attached to the display panel
through the slot on the upper CPU cover and lift the display panel off of the unit.
Important: When removing the display panel assembly, take note of the correct routing
position for the display flex cable for use during replacement.
Note: For TFT displays, Compaq recommends replacing the LVDS connector on the end
of the display flex cable after the display panel assembly has been removed from the
unit.
To replace the display panel, reverse these procedures.
30 R S
EMOVAL EQUENCE
Presario 1200 Series
Models: XL101-XL113, XL115, XL118-XL127
1
grasping the edges of the connector and
P N M
RESARIO OTEBOOK AINTENANCE AND
2
gently pulling out the
S G 1200XL S
ERVICE UIDE ERIES