How To Set The Time And Date - ADEMCO 6270 - TouchCenter Keypad User Manual

6270 Setup (cont'd)

How to Set the Time and Date

You can set the time and date from the Set Time & Date screen.
Pressing the Time and Date bar located at the bottom of each 6270
screen displays the Set Time & Date screen.
When the time is set it will be stored in the 6270 only. The 6270
N
will send the time to the control panel every hour. This 1-hour
timer starts on 6270 power-up.
If Adjust for DST (Daylight Savings Time) is selected, the 6270
N
will adjust for Daylight Savings time. When selected, the next
time the 1-hour timer expires, the new value will be sent to the
control panel.
IMPORTANT: This means that the 6270 setting will override and
overwrite the control panel time setting. That is, if the control panel
is set to DST and adjusts but the 6270 is not, upon the 1-hour timer
expiration, the control panel will be updated to the current time that
is not adjusted for DST.
From the Set Time & Date screen, adjust either or both the time
and date by pressing the increase or decrease arrow buttons as
necessary until the proper month, day, year, hour, and minute are
displayed.
OK
BUTTON
Set Time & Date Screen
54
INCREASE
BUTTON
(TYPICAL)
DECREASE
BUTTON
(TYPICAL)
CANCEL
BUTTON
6270-008-V0