Hoisting; Jump-Starting - Dodge 2010 Ram Truck Chassis Owner's Manual

Disc Wheels Type Nut
Cone
Flanged
To Stow The Flat Or Spare — If Equipped
Refer to Upfitters Body Builders Guide for information
on stowing your spare tire (if equipped).

HOISTING

A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking loca-
tions. However, a floor jack or frame hoist must never be
used on any other parts or the underbody.
CAUTION!
Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.
Stud Size Torque Ft Lbs
9/16-18 120-150
9/16-18 130-160

JUMP-STARTING

• To prevent personal injury or damage to clothing,
do not allow battery fluid to contact eyes, skin or
fabrics. Do not lean over a battery when connect-
ing jumper cables or allow cable clamps to touch
each other. Keep open flames or sparks away from
battery vent holes. Always wear eye protection
when working with batteries.
• Do not use a booster battery or any other booster
source that has a greater than 12-Volt system, i.e.,
do not use a 24-Volt power source.
WHAT TO DO IN EMERGENCIES 307
Torque Newton Meters
160-200
190-220
WARNING!
6