Table of Contents
Advertisement
Figure 4-11 Shows the loaded Broadcom Gigabit driver
4. Select Continue and continue the NetWare installation as per usual.
Once the NetWare installation is complete, install the latest service pack. This
can be done using the NWCONFIG utility.
Installing additional drivers
When the NetWare 6 and Support Pack installation has completed, you should
perform the updates listed below. The order of these updates is not critical, but
we recommend that you install the latest Support Pack prior to installing the
device drivers.
Update the ServeRAID adapter driver.
Install the driver for Remote Supervisor Adapter (run SETUP.NLM, follow the
instructions, and restart NetWare).
Install driver for PCI hot-plug controller, as described below.
Installing the IBM PCI hot-plug controller driver
1. Ensure that NetWare Support Pack 1 is installed, since it is required before
the driver can be installed.
2. Download the PCI hot-plug driver from the link listed at the beginning of this
section.
3. Copy the PCI hot-plug driver (IBMXSBD.NLM) to hard drive (C:\)
124
IBM ^ xSeries 440 Planning and Installation Guide
Advertisement
Table of Contents
