Preinstallation Steps; Installing A Drive In Bay 2 - IBM 8647 - Eserver xSeries 225 Installation Manual

Preinstallation steps

Some of these steps are required only the first time a drive is installed in a specific
bay:
1. Review the safety information beginning on page v and the documentation that
2. Verify that you have all the cables and other equipment specified in the
3. Choose the bay in which you want to install the drive.
4. Check the instructions that come with the drive to see if you need to set any

Installing a drive in bay 2

Complete the following steps to install a drive in bay 2:
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could result in
v Use of controls or adjustments or performance of procedures other than those
comes with your drive.
documentation that comes with the drive.
switches or jumpers on the drive. If you are installing a SCSI device, be sure to
set the SCSI ID for that device.
1. Follow the instructions in "Preinstallation steps" on page 21.
2. Remove the side cover (see "Removing the side cover" on page 11).
3. Remove the bezel (see "Removing the bezel" on page 12).
4. Remove the support bracket (see "Removing and installing the support
bracket" on page 13).
5. Use a screwdriver to pry the filler panel and EMC shield away from the server.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
specified herein might result in hazardous radiation exposure.
Danger
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the
following. Laser radiation when open. Do not stare into the beam, do not view directly with
optical instruments, and avoid direct exposure to the beam.
Chapter 2. Installing options
21