Table of Contents
Advertisement
Figure 10. Installing the memory module
8. Reinstall any parts and reconnect any cables that have been removed.
9. Go to "Completing the FRU replacement" on page 84.
Replacing the hard disk drive
Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 67.
2. Locate the primary hard disk drive..
Note: There is also a secondary hard disk drive bay for you to install a secondary hard disk drive by
yourself. If you want to install a secondary hard disk drive, use the same way of installing the primary
hard disk drive.
3. Disconnect the signal cable and the power cable from the rear of the hard disk drive.
4. Remove the four screws that secure the hard disk drive. Then, slide the hard disk drive out of the chassis.
.
Chapter 8
Replacing FRUs (Type 0841)
79
Advertisement
Table of Contents
