Table of Contents
Advertisement
Selecting a startup device
If your computer does not start up from a device such as the hard disk drive or the disc in the optical drive as
expected, do one of the following to select the startup device you want.
Selecting a temporary startup device
Use this procedure to start up from any startup device.
Note: Not all discs, hard disk drives, and diskettes are bootable.
To select a temporary startup device, do the following:
1. Turn off your computer.
2. Repeatedly press and release the F12 key when turning on the computer. When the Startup Device
Menu opens, release the F12 key.
3. Select the desired startup device from the Startup Device Menu and press Enter to begin.
Note: Selecting a startup device from the Startup Device Menu does not permanently change the startup
sequence.
Selecting or changing the startup device sequence
To view or permanently change the configured startup device sequence, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 37.
2. Select Startup ® Primary Boot Sequence. Read the information displayed on the right side of the
screen.
3. Select the first boot device, second boot device, and so on.
4. Press Esc to return to the Startup menu. Then, select the devices for the Automatic Boot Sequence
and Error Boot Sequence.
5. Press Esc to return to the Setup Utility program main menu. You might have to press Esc several times.
6. Press F10 to save and exit the Setup Utility program.
Note: If you do not want to save the settings, select Exit ® Discard Changes and Exit.
If you have changed the settings and want to return to the default settings, select Load Optimal Defaults
on the Exit menu.
Exiting from the Setup Utility program
After you finish viewing or changing settings, press Esc to return to the Setup Utility program main menu.
You might have to press Esc several times. If you want to save the new settings, press F10 to save and exit
the Setup Utility program. Otherwise, your changes will not be saved.
.
Chapter 6
Using the Setup Utility
39
Advertisement
Table of Contents
