Rke Transmitter Battery Service - Dodge 2009 Ram 1500 Owner's Manual

24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

RKE Transmitter Battery Service

1. With RKE transmitter buttons facing down, use a flat
blade or dime to pry the two halves of the RKE transmit-
ter apart. Make sure not to damage the rubber gasket
during removal.
RKE Transmitter Battery Replacement
2. Remove and replace the battery. When replacing the
battery, match the + sign on battery to the + sign on the
inside of the battery clip, located on back cover. Avoid
touching the new battery with your fingers. Skin oils may
cause battery deterioration. If you touch a battery, clean it
with rubbing alcohol.
3. To reassemble the RKE transmitter case, snap the two
halves of the case together. Make sure there is an even
"gap" between the two halves. If equipped, install and
tighten the screw until snug. Test the RKE transmitter
operation.
NOTE:
• Perchlorate Material – special handling may apply, see
www.dtsc.ca.gov/hazardouswaste/perchlorate
• The recommended replacement battery is CR2032.
• Do not touch the battery terminals that are on the back
housing or the printed circuit board.