Maytag MGC4436BDC - 36in Gas Cooktops Installation Manual page 8

B. INVERT CAP IN APPLIANCE PRESSURE
REGULATOR (See figure 10)
With the appliance installed, the appliance regulator
should be located as shown in figures 3 or 4.
CONVERSION OF APPLIANCE APPLY DOWNWARD
PRESSURE REGULATOR FINGER PRESSURE
ATDISC EDGES TO
R._LP REPLACE PiN iNCAP.
CONVERTE APPLY S IDEWARD
CAP I _ FINGER P RESSURE
tr
_'AND PiN J TOREMOVE PiN
.t/" (_ FROM CAP
NAT'
J'_
NAT J
J LP
L.j_ -- _
C. LOW FLAME ADJUSTMENT (See figure 11)
This appliance is shipped from the factory with low and
high flame settings adjusted for use with natural gas.
To set for use with LP proceed as follows:
1. Remove control knob from valve stem.
CAUTION:
NEVER USE A METAL BLADE TO
PRY KNOB OFE IF KNOB CANNOT BE EASILY
R E MOV E D; TUC K TH E FO LDS O F A C LOTH
DISHTOWEL UNDER THE KNOB AND PULL THE
TOWEL UPWARD WITH STEADY, EVEN PRES,
SURE.
2. Carefully remove rubber grommet.
3. Locate the valve adjustment screw. See figure 11.
4. Insert a slender, thin-blade screwdriver into knob
hole and engage blade with slot in adjusting screw.
5. Turn the adjusting screw clockwise until tight (5-7
in-lbs max.). Do not over tighten.
6. Replace rubber grommet and control knob.
7. Repeat for remaining burners.
KNOB
_KNOB HOLE _
(KNOB AND GROMMET REMOVED)
FIGURE11
After adjusting the screw the burner should produce a
stable, steady blue flame of minimum size. The setting
should be checked by turning knob from high to low
several times without extinguishing the flame.
This operation will automatically provide the proper flame
size at medium setting.
After Conversion Steps A, B and C have been completed,
check the appearance of each burner flame at the Hi and
Lo settings against figure 12. If the flames appear too
large or too small, review each step to make sure it was
completed correctly.
FLAME APPEARANCE AT Hi AND LO
FIGURE 12