Warranty Information - Timex T436B - Clock Radio With Time Projector Instruction Manual

Projection alarm clock radio with nature sounds
Table of Contents

Advertisement

Limited 90-Day Warranty Information
Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product
to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date
of original purchase.
Should service be required by reason of any defect or malfunction during the warranty period, SDI Technologies will repair
or, at its discretion, replace this product without charge (except for a $10.00 charge for handling, packing, return
UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product
to the Factory Service Center listed below. The product must include proof of purchase, including date of purchase. The fee
for service after the warranty period or without proof of purchase is $30.00.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or
defective batteries are the most common cause of problems encountered.
If service is still required:
1. Remove batteries (if applicable) and pack the unit in a well-padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase.
3. Enclose a check or money order payable to the order of SDI Technologies, Inc. for the sum of $10.00 (or $30.00 if after
the warranty period or without proof of purchase).
4. Send the unit prepaid to the Factory Service Center listed below:
Consumer Repair Department
SDI Technologies Inc.
Timex Audio Products Division
1330 Goodyear Drive
El Paso TX 79936-6420
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i)
products which have been damaged by negligence, misuse or accident, or which have been modified or repaired by
unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to tape cassettes (if
applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the product subsequent to the
original purchaser. Any applicable implied warranties are also limited to 90 days, and SDI Technologies will not be liable for
consequential damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages,
so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
© 2008 SDI Technologies, Inc. All rights reserved
TIMEX is a registered trademark of Timex Corporation the United States and other countries
T436-130708-A
Printed in China

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T436B - Clock Radio With Time Projector and is the answer not in the manual?

Questions and answers

Russell A Moore Sr
March 15, 2025

My dad bought the T436B 06Jan2023. He passed away the day before Mother's day. I have it now. The projector does not work. What can you do to help me get this fixed?

1 comments:
Mr. Anderson
March 15, 2025

To fix the projector on the Timex T436B Clock Radio, follow these steps:

1. Check the Projection Switch – Ensure the Projection Switch on the right side of the unit is set to "Time" to project the time or "Time/Alarm" to project both the time and the earliest set alarm time. If it is set to "Off," the projection function will not work.

2. Adjust the Projector Arm – Tilt the projector arm to aim the projected display for the best viewing angle.

3. Focus the Image – Turn the Focus Dial to adjust the sharpness of the projected image.

4. Flip the Image – If needed, press the Flip Image Button to rotate the projection vertically.

If the projector still does not work, check that the clock radio is properly powered and that there are no obstructions blocking the projection lens.

This answer is automatically generated

Ron
April 20, 2025

Cannot get any sound from the unit.

1 comments:
Mr. Anderson
May 10, 2025

The Timex T436B Clock Radio With Time Projector may produce no sound if the unit is turned off. Press the Alarm Reset/Power On/Off Button to turn it on. If the unit is in Sleep Mode, it may have shut off automatically after the selected time. Other possible reasons not directly stated but implied by the manual include improper use, damage due to heat, moisture exposure, or blocked ventilation, which could affect internal components.

This answer is automatically generated

This manual is also suitable for:

T436

Table of Contents

Save PDF