Honeywell 4820HDHM User Manual page 141

UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of
the scanned data or not. Default = On.
* On
UPC-E0 Number System
The numeric system digit of a UPC symbol is normally transmitted at the begin-
ning of the scanned data, but the unit can be programmed so it will not transmit
it. To prevent transmission, scan Off. Default = On.
* On
UPC-E0 Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-E data.
Default = Off for both 2 Digit and 5 Digit Addenda.
2 Digit Addenda On
5 Digit Addenda On
Off
Off
* 2 Digit Addenda Off
* 5 Digit Addenda Off
7 - 23