Connecting The Base With Rs-232 Serial Port; Connecting The Base With Rs-232 Wedge - Honeywell 4820HDHM User Manual

2d cordless imaging system
Hide thumbs Also See for 4820HDHM:
Table of Contents

Advertisement

Connecting the Base with RS-232 Serial Port

1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the base. Make sure the cables
are secured in the wireways in the bottom of the base and that the base sits
flat on a horizontal surface.
Note: For the base to work properly, you must have the correct cable for your
type of terminal/computer.
3. Plug the serial connector into the serial port on your computer. Tighten the
two screws to secure the connector to the port.
4. Once the image scanner has been fully connected, power up the computer.

Connecting the Base with RS-232 Wedge

The 2020 uses TTL signal levels to wedge into an RS-232 serial network. Use
only 2020 serial wedge cables to prevent damage to the base. Refer to
Baud Rate
on page 2-16 to set the baud rate and communications protocol.
1. Turn off power to the computer.
2. Disconnect the existing serial cable from the computer.
1 - 6
RS-232

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

202048204820i

Table of Contents