HAMPTON BAY HB1004C Owner's Manual page 14

tnsta//ation
7, Measure height of window opening from top
of Bracket assembly as shown Fig. 5,
Subtract 20-3/4 inches, Mark this
measurement on Cu_ain and cut the Curtain,
(Fig. 5)
8. Slide Curtain into Curtain Frame. S_id,e
Curtain Frame assemb4y imo side Guides of
the Air Conditioner cabinet. Make sure
Curtain is firmly enclosed o,n alil sides by the
Frame, (Fig. 6)
" Fig. 5
9. Cut side Guide sea_ into 2 equall lengths.
Remove protective backing and apply it to, the
rear side of cabinet Side Guides, starting just
below Curtain Frame assembly. Pinch off
excess length so seal is even with the bottom
of side Guide. (Fig. 7)
10, Place Air Conditioner in window opening, It
should sit on Bracket assembly so, that
Curtain Frame and cabinet Side Guides are
against top, and side window jambs Mate
front of Bracket with Base Guide attach_ to
the bottom of base pan,
11, Drill 1/8 inch holes in window track mrough
the existing holes on Base Guide. Screw 4
_y_ C screws through me holies. (Fig. 8)
12. if this is a casement window instal!lation,
proceed to Casement Window Installation, ff
not, slide inner window sash firmly against
side of me cabinet.
13, Drill 1/8 inch hole in window jamb to align
with the existing holes in me Curtain Frame,
A_ach Curtain Frame to window frame with
2 Ty_ B screws (Fig, 8)
,_ather sea_
to side guides
iust below e_e of
,Cl_rtain Frame
Ty_ C scr_
Ty_ B
Window Track
14 Room Air CoinditioRef
Fig, 8