HAMPTON BAY HB1004C Owner's Manual page 13

tns._ltation
1. Loosely attach the Support Bracket to the
bottom of Bracket using Bolts, Washer; and
Nuts. Attach the Leveling Bott and Nu¢ (Fig,
1/
2. Remove protective backing from Window
Track Seal and apply seal to,window tra,_.
(Fig,2)
Sup_rt
Bracket
Fig. i
3, Measure and lightly mark a line 8-t/4 inches
from window iambi, Center the Support
Bracket a ssemHy on the window track and
fasten with 4 Type C _rewso(Fig_ 2)
4. Put the Support Bracket against the outside
wall and tighten the Bolts on top, of the
Bracket, Adjust the Leveling Bolt _ that the
air ,conditioner will Ibe installed with a very
slight tilt (about t/4") downward toward the
outside for proper drainage,
Tighten the nut. (Fig. 3)
DO NOT drill a hole in the bottom of
the base pan. The ,air ,condffiioner is
designed to operate w_h the bottom
of the I_se pan ap,pro,ximately haft-full
of water.
5, Fasten Side Guides to the sides of the Air
Conditioner using 3 _:/_ A screws _r Guide,
Start with first screw at middle of Guide.
(Fig. 4 )
6, Fasten Upper Guide on the top of the Air
Conditioner using 3 Type A screw& (Fig. 4)
J,a_ i b......
_ :Wi:i
i 'Track
J
Fig. 2
A_ut:
Fig. 3
Fastening Side Guides
Upper
Side Guide
Fig, 4
Owne. s Manual 13