Water Drainage; How To Use - Duracraft DD-TEC10E Instruction Manual

ENGLISH
19 Swimmer
20 Air filter
FIRST TIME OF USE
1. Please read through all the instructions before starting
to use the dehumidifier.
2. Unpack the dehumidifier. Remove all the packaging
materials and dispose of them for recycling.
3. Place the dehumidifier on a firm, even, waterproof sur-
face. Water can damage furniture and floor coverings and
lead to fire or electric shock. Make sure the dehumidifier is
standing securely so that it cannot tip over or fall down.
Observe the safety distances as given in Point 10 of
"Important safety instructions".

WATER DRAINAGE

The dehumidifier provides two ways of emptying the water.
PLEASE NOTE: Do not reuse the collected distilled water.
Water tank, 2.9 liters
1. When the water tank (15) is full, the control lamp (7)
flashes. The dehumidifying operation is stopped automati-
cally.
2. Wait for about 30 minutes before removing the water
tank (15), so that the remaining water can drip down into
it. Hence do not remove the water tank when the dehumi-
difier is in use or has just been switched off.
3. Take hold of the two cavities on the sides of the water
tank (15) and pull it out carefully with both hands. "P2"
appears on the display (5).
4. Empty the water only on the side opposite the swimmer
(19).
5. Now push the water tank (15) back into its original
position with both hands until you hear it click into place.
The control lamp (7) goes off. The relative humidity appe-
ars on the display (5).
6. If the control lamp (7) does not go off, pull the water
tank (15) out again.
7. Check that the swimmer (19) is correctly installed. The
swimmer must not be removed, because otherwise the
automatic interruption of the dehumidifying operation is
not guaranteed. Overflowing water can damage objects
and floor coverings or cause an electric shock.
8. Now replace the water tank (15) as described under
Point 5.
Continuous water drainage
If you wish to install continuous water drainage, please
proceed as follows. Please note: The dehumidifying opera-
tion is not interrupted in this kind of water drainage.
1. Make sure that the dehumidifier is switched off. Discon-
nect the power plug from the power socket.
2. Carefully remove the cover of the opening (16) on the
rear side of the appliance with a pair of pliers or a similar
tool. (Fig. 1)
3. Remove the water tank (15). Push the water tube (insi-
de diameter 16mm) through the opening (16) and push it
in. Press the water tube firmly onto the water connection
(17) in the appliance. Make sure that the water tube is
firmly fixed to the water connections and cannot become
detached. (Fig. 2)
4. Put the water tube directly into a water drain. Check that
the pipe is sloping downwards throughout its length, and
is not buckled, knotted or blocked, so that the water can
drain off freely. Check the safe and leakproof position of
the water tube regularly.
5. Push the water tank (15) with both hands into its origi-
nal position until you hear it click into place.
INSTRUCTIONS FOR USE
1. Push the power plug into the power socket. Do not
touch the power cord with wet hands. The power control
lamp flashes.
2. Make sure that the air intake and air outlet openings
(9+10) are open. The air intake and air outlet openings
must always be open during the dehumidifying operation.
3. Press the power key (2) to start using the dehumidifier.
The power control lamp (6) lights up. The degree of relati-
ve humidity actually present in the room appears on the
display.
4. The dehumidifier is programmed ex factory to a relative
humidity of 60%. To lower the degree of relative humidity,
press this key (4); to raise it, press this key
You can select between 35 and 80 % RH.
5. When the dehumidifier has reached the programmed
humidity, it interrupts the dehumidifying operation and
only resumes it when the relative humidity in the room
exceeds the programmed value.
6. To allow the dehumidifier to operate continuously, press
this key (3). The relative humidity can be programmed
with these keys: and
7. Use the transport handle (11) and the transport castors
(12) to transport the dehumidifier.
8. To support the dehumidifying achievement, close
windows and doors in the room in which you are using the
dehumidifier. When it is used e.g. in the laundry room,
make sure that no water can drip onto or into the dehumi-
difier and observe the safety distances as described under
"Important safety instructions".
6
(4).
(4).