Inline Fuel Filter; Tires And Wheels; Tire & Wheel Inspection; Tire Pressure - DAELIM ET-300 - SERVICE MANUAL BIS Service Manual

atically shut off when the engine is stopped.
The fuel will automatically begin to flow when
the engine is turned over.
To test the fuel valve remove the fuel line from
the carburetor and place the end in a container
to catch the fuel. Insure that your tank has fuel
and press the starter button. Fuel should flow
Into the container from the fuel line.
When the fuel valve set on the "PRI" Position,
the unit is not equipped with a vacuum
controlled fuel valve. The fuel will flow to the
carburetor directly.
The purposes of "PRI" include two functions.
One is let fuel flow out when repairing ATV,
another reason is if all above operations fail,
the user can turn the fuel valve to
in order to let fuel flow into the carburetor
favorably.
ALWA YS CHECK YOUR Fuel level before
you start riding your ATV . Remember:
You can drive further in one hour on your ATV
than you can walk in one day.

Inline Fuel Filter

Your ATV is equipped with an inline fuel filter
to prevent dirt and debris from entering the
carburetor and engine.
Check the filter for dirt or damage before each
ride and at each refueling. Replace the filter if
dirty or damaged.
DO NOT operate the unit with out a fuel filter.
Doing so can cause damage to the carburetor
and engine.
Inline Fuel Filter
The filter should be replaced every 600 hours
of operation and at the start of each season.
To replace the filter, first turn the fuel valve to
the "ON" or "RES" position. Then carefully
compress the wire clamp rings until the clamp
is free of the fuel line. Slide each clamp away
from the filter about 3/4".
CONTROL FEATURES
Remove the filter from the fuel line by holding
the line and pulling the filter. Install the new
filter by inserting the filter into the fuel line and
returning the clamps to the original position.
Turn the fuel valve to the "PRI" position and
check for leaks. Inspect the fuel lines for cuts,
abrasions and deterioration. Replace fuel lines
as needed. Return the fuel valve to the "ON"
position for normal operations.
DO NOT start or operate the engine if the fuel
filter or lines are leaking. Leaking fuel can
cause a fire.
"PRI" position
It is important to inspect your tires and wheels
for damage and wear before each riding
session. Inspect each tire for cuts, tears and
punctures. Inspect the wheel rim for dents and
separation of the wheel from the tire bead.
Replace any tire or wheel found to be
damaged.
Operating your ATV with damaged tires or
wheels is dangerous. Damaged tires or wheels
can result in a sudden loss of tire pressure and
control which could result in injuries.
Check your tire pressure before each riding
session and at each refueling operation.
Always check the pressure when the tires are
cool. Use the tire pressure gauge that came
with your ATV to check the tire pressure.

TIRES AND WHEELS

Tire & Wheel inspection
Wheel Nuts torque 24-30 N/m (18-22 1b/ft)

Tire Pressure