Fuel Valve; Inline Fuel Filter - DAELIM ET250 Owner's Manual

Every time you refuel your unit, check the
rubber seal inside the cap for cuts, tears and
dirt. Clean or replace the seal if it becomes
worn or torn. The seal must be in good
condition to insure a proper seal of the cap to
the tank to prevent fuel spills. DO NOT allow
dirt or other debris to enter the tank when
refueling.
Replace the cap if damaged or if it will not seal
to the tank.
Tighten the cap snugly, being careful not to
over tighten. Over tightening the cap can
cause damage to the cap or seal.
The fuel tank capacity is
including a reserve of 2.5 liters, 0.66 gal.
Use unleaded automobile gasoline with an
octane level of 91 or higher.
Your ATV is equipped with a fuel gage located
in the instrument cluster between the handlebars.
NEVER REFUEL YOUR ATV when the
engine is HOT. Wait 30 minutes after turning
off the unit before refueling. Spilling fuel on a
HOT engine could cause a fire. Wipe up any
fuel spills before re-starting.

Fuel Valve

The unit is equipped with a three way fuel
valve located on the left side of the unit just
below the seat.
The valve has three settings; "ON", "RES"
and "PRI" .
PRI
Place the valve in the "ON" for normal operation
of the unit.This allows fuel to flow to the
carburetor for normal operating. The "RES"
position allows fuel to flow from the small
reserve in the tank to allow the unit to be
taken to a refueling location. When you have
to switch to the "RES" position you must refuel
the unit as soon as possible.
CONTROL FEATURES CONTROL FEATURES
12 liters, 3.17 gal ,
ON
RES
When the fuel valve set on the
position, the unit is equipped with a vacuum
controlled fuel valve. The fuel supply is autom
atically shut off when the engine is stopped.
The fuel will automatically begin to flow when
the engine is turned over.
To test the fuel valve remo ve the fuel line from
the carburetor and place the end in a container
to catch the fuel. Insure that your tank has fuel
and press the starter button. Fuel should flow
Into the container from the fuel line.
Fuel Line
Vacumn Control
When the fuel valve set on the
the unit is not equipped with a vacuum
controlled fuel valve. The fuel will flow to the
carburetor directly.
The purposes of "PRI" include two functions.
One is let fuel flow out when repairing ATV,
another reason is if all above operations fail,
the user can turn the fuel valve to
in order to let fuel flow into the carburetor
favorably.
ALWA YS CHECK YOUR Fuel level before
you start riding your ATV . Remember:
You can drive further in one hour on your ATV
than you can walk in one day.

Inline Fuel Filter

Your ATV is equipped with an inline fuel filter
to prevent dirt and debris from entering the
carburetor and engine.
Check the filter for dirt or damage before each
ride and at each refueling. Replace the filter if
dirty or damaged.
DO NOT operate the unit with out a fuel filter.
Doing so can cause damage to the carburetor
and engine.
"ON" or "RES"
Line
"PRI" Position,
"PRI" position